Drawing and material
Provide the drawing revision, material grade and sheet thickness.
Factory Tour · Process principles
Follow the interface from flat blank to formed part.
Hole locations, bends and mating faces define the stamped component. Review the final formed condition alongside the flat pattern, sheet material and tooling plan.
Material ranges, thicknesses, tolerances and the manufacturing location are confirmed during project review.
Flat blankFormed interfaces
Review holes and mating faces in the finished condition.
Define the requirement
Bring the drawing, material and acceptance inputs.
Formed geometry
Identify bend direction, hole patterns, datum faces and the surfaces that mate.
Edge and finish
Specify burr direction, edge condition, surface treatment, sample quantity and acceptance.
Process principles
The bend changes how the features relate.
Plan the blank and the forming sequence around the finished assembly interfaces.
Locate
Define datum faces, hole positions and mating surfaces on the drawing.
Form
Review blank geometry, bend sequence, flange angle and springback acceptance.
Approve tooling and samples
Agree tooling responsibilities, samples and the approval route.
Inspect and protect
Verify the formed features, edge condition and finish; agree packing and repeat-order records.
Verification and records
Measure the formed part, not only the flat pattern.
Mounting plates
Record the critical hole positions against the approved datums.
Formed brackets
Check bend position, flange angle and the relationship between mating faces.
Finished components
Agree burr, edge and finish inspection with sample approval and protective packing.
Project review
Connect the route to your requirement.
Send the material or drawing definition, intended use and the acceptance records needed for review.